| Electronics > Projects, Designs, and Technical Stuff |
| ZVS Induction heater 2000W 40A 50V |
| << < (6/7) > >> |
| RolingStones:
Looks impressive and well build May I ask if you if you have tried using litz wire for heating coil instead of the copper tube? I have been working with a smaller 1000W ZVS drive and trying to optimize the electrical hysteresis by heating an iron pipe (high ferromagnetic material). Using a copper tube as heating coil the iron (Fe) heats faster than when using a litz wire. Theoretically it should be the other way around. |
| RolingStones:
--- Quote from: strawberry on September 27, 2017, 07:18:51 pm ---Lepel RF generator is something new for me, is it using vacuum tubes? Do you have schematic? I am planing to build mains powered PLL induction heater. I am aiming on about 3kW power --- End quote --- Were you able to design the 3kW? I would be very interested in seeing it in action. |
| SharkyJr:
Hey thanks for sharing this! Im a beginner in Electronics and i wanted to know what should be the power rating of the resistors? I noticed in the order history, you shared on Drive, that the 1k and the 10K are 1/4W but no info on the other ones. |
| aamirchef135:
Where I can buy it and how much please Sent from my SM-G935F using Tapatalk |
| DR Martin:
Do you have the Altium source files for you rev. 2 board with protection? |
| Navigation |
| Message Index |
| Next page |
| Previous page |