Electronics > Projects, Designs, and Technical Stuff

ZX7-200 inverter welder teardown

<< < (3/4) > >>

friedolino:

--- Quote from: ealex on September 24, 2019, 07:57:13 pm ---
i just got the parts needed to try to convert it into a spot welder
i'll update this thread when I'll start working on it - especially if it's a spectacular failure
(i'll do the first test outside to minimize the things that can burn, if I'll make a 18650 cell  blow up)

--- End quote ---

im interested in this mod, too. would like to know if this device is suited to spot welder 0.1mm sheets of stainless steel. Which electrodes do you use?

ealex:
hello
the project is currently on hold - i've been busy with some other things.
pretty much everything is done, I just need to connect everything and test it.

for electrodes i plan to use some thick copper wire that's connected to the output cables with some stainless steel screws

friedolino:
do you have more ressources / references for spot weling with arc welding machine?

I found only this video:


ealex:
no, i don't have any extra info.

and the bad part is that I don't have where to get any - the entire area is dead from the machining point of view - i'm just experimenting / learning everything as I go.


(dead - took me 3 months to find someone with a lathe, to make a part that needed 30 minutes of work)

acruse60:
does the cooling fan start running when power is switched on?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod