Author Topic: Proteus ARES PCB - How to wire a link pad to some component pad.  (Read 6555 times)

0 Members and 1 Guest are viewing this topic.

Offline OshioTopic starter

  • Newbie
  • Posts: 1
  • Country: br
I'm designing a single side pcb, due to trail's density, I decided to use link wires in order to avoid overlap, but when I started routing, the software didn't allow me to connect any wire to link's pad. I tried to assign some netclass but couldn't find a way to that. Sometimes, only by luck, I successfully make the connection, but I'm clueless about what made it possible. I attached a picture that illustrates both situations.
I'm using Proteus 8.6 SP2.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf