Electronics > Proteus

Problem with custom made transformer in Proteus

(1/1)

prakash.srivastava:
Hi All,
For my SMPS project, I made a custom transformer in proteus 8.1. I took the base transformer model TRAN-2P3S from standard Proetus library and modified to TRAN-2P6S (with 6 secondary). Before integrating this custom made transformer, I tried to test it by applying the square pulse through a pulse generator. The original one gives the output but custom made transformer doesn't. Though I defined all I/P and O/P points in child sheet. Can some one pls help me?
Pls download the circuit from below link...I defined the child sheet also in test simulation.
https://drive.google.com/drive/folders/1u1zWlUME-GR_Uujg231SRth5J4qkF2wM?usp=sharing
The simulation file is also attached with the message.
Thanks for your help in advance guys.
Best regards
Prakash

woofy:
Most likely, you have not included the new windings in the spice model.

prakash.srivastava:
Of course, I included the windings. Pls down load the Proteus model and have a look.

prakash.srivastava:
can someone help on this Proteus topic?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version