EEVblog Electronics Community Forum

Electronics => PCB/EDA/CAD => Proteus => Topic started by: Oshio on January 07, 2018, 09:53:09 pm

Title: Proteus ARES PCB - How to wire a link pad to some component pad.
Post by: Oshio on January 07, 2018, 09:53:09 pm
I'm designing a single side pcb, due to trail's density, I decided to use link wires in order to avoid overlap, but when I started routing, the software didn't allow me to connect any wire to link's pad. I tried to assign some netclass but couldn't find a way to that. Sometimes, only by luck, I successfully make the connection, but I'm clueless about what made it possible. I attached a picture that illustrates both situations.
I'm using Proteus 8.6 SP2.