Author Topic: Proteus Design Suite Automatically closes uncertainly.  (Read 186 times)

0 Members and 1 Guest are viewing this topic.

Offline Siddhat

  • Contributor
  • Posts: 17
  • Country: np
Proteus Design Suite Automatically closes uncertainly.
« on: September 22, 2019, 04:55:34 pm »
Hey guys, I just installed Proteus Design Suite v8.9 on my computer. But the problem is that the software automatically closes when a simulation is running, or when a schematic is being made. Even during a simple circuit simulation of a Battery, resistor and a LED, the software closes. I've had this problem in Proteus v8.7, v8.8 and now v8.9. I updated to 8.9 hoping the problem would solve but it is still the same. I've lost so many important schematics till now, even when designing it's not just convenient. Anyone facing the same problems? And any ideas how to solve the problems? Appreciate your help.
 

Offline Simon

  • Global Moderator
  • *****
  • Posts: 13646
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
Re: Proteus Design Suite Automatically closes uncertainly.
« Reply #1 on: September 22, 2019, 06:22:24 pm »
Contact their support. They are generally quite good and unlike other vendors will genuinely investigate.
https://www.simonselectronics.co.uk/shop
Varied stock of test instruments and components including EEVblog gear and Wurth Elektronik Books.
Also, if you want to get ripped off: https://www.ebay.co.uk/usr/simons_electronics?_trksid=p2047675.l2559
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf