Author Topic: Easy way to wind flyback transformer on ETD29?  (Read 410 times)

0 Members and 1 Guest are viewing this topic.

Offline Faringdon

  • Frequent Contributor
  • **
  • Posts: 997
  • Country: gb
Easy way to wind flyback transformer on ETD29?
« on: May 17, 2022, 12:09:24 pm »
Hi,
Can we wind our ETD29 flyback transformer without terminating the windings to the pins? (as attached). We will just terminate to pads which we will put on the PCB.
We are very club-handed, we struggle winding transformers.
Winding a layer, then taping it, then bringing the wire neatly back across for termination is tricky, and results in too much windings depth on the former.
Its only for a prototype board.

ETD29
https://www.tdk-electronics.tdk.com/inf/80/db/fer/etd_29_16_10.pdf
« Last Edit: May 17, 2022, 04:35:36 pm by Faringdon »
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf