EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: Hrvoje_CRO on June 11, 2023, 12:14:19 pm
-
Hello dear people!
I have an issue/concern with my 2 34410A.
When in resistance mode, if i touch the probes (insulated parts, not the tips!), relay inside clicks over and over.
Please see a video, and sorry for potentially shaky video.
https://easyupload.io/wllctr
Thank you in advance!
-
There are a few spots on the resistance scale of the 34410A and also the 34411A when the relay clicks between rages, since this instrument can measure in the G-ohm range.
All my 34410A do the same, so no worries.
-
Same here
-
Hmm, strange is how i didn't noticed this behaviour before |O .
Whatsoever, thank you a lot!
Oh yes, i almost forgot to mention, these instruments (34410A) are "buggy", they have a design flaw with autorange mode. Check this:
https://community.keysight.com/s/question/0D52L00005IdprESAR/34410a-autorange-issue-when-selected-resistance
Kind Regards,
Hrvoje
-
Hmm, strange is how i didn't noticed this behaviour before |O .
Whatsoever, thank you a lot!
Oh yes, i almost forgot to mention, these instruments (34410A) are "buggy", they have a design flaw with autorange mode. Check this:
https://community.keysight.com/s/question/0D52L00005IdprESAR/34410a-autorange-issue-when-selected-resistance
Kind Regards,
Hrvoje
These instruments are not buggy at all.
Yes, this is a known small issue but easy to work around.
These multimeters are considered to be the best 6 1/2 digit DMM ever built. (At least my opinion)
They are just amazing when used correctly.
-
I must agree with you, this is why i did put buggy under quotation marks.