Electronics > Repair

3D printing knobs?

(1/1)

Axtman:
Does anyone here 3D print items? I am interested having someone print me about a dozen knobs for an old Univox guitar amplifier. Thanks.

Swainster:
I do, but I'm based in Singapore. If you have no luck here then you could probably find someone closer on Reddit

mag_therm:
Did you do a search for "NOS" knobs etc or try search generic "guitar amp knobs"?
I recently restored an old Bogen amp and found the original skirted  knobs available from more than one supplier.
like here:
https://www.surplussales.com/ShaftHardware/Knobs-10.html (there are other pages)

george.b:
In the US you could try Shapeways or something, I guess?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version