« previous next »
Pages: [1]   Go Down

Author Topic: Agilen 8563EC  (Read 561 times)

0 Members and 1 Guest are viewing this topic.

Offline tchiwamTopic starter

  • Regular Contributor
  • *
  • Posts: 134
  • Country: ca
Agilen 8563EC
« on: June 13, 2023, 04:53:20 pm »
C716 tantalum short

Now only having a straight line above the scale across the range...

I 'm suspecting the U909 MC33284D to have disliked a negative input while the -15VDC was near 0V shorted by the C716...

IF on A3 is complaining too... so I guess that it might not behave until the GAIN is about right.

All input and outputs are near the same potential, it looks like it got hot too...

Anyway... ordered the part, let's hope :(

Logged
 

Offline tchiwamTopic starter

  • Regular Contributor
  • *
  • Posts: 134
  • Country: ca
Re: Agilen 8563EC
« Reply #1 on: June 13, 2023, 05:08:14 pm »
The suspect U909 that go hot ...

Both rails are good measured on the side of the caps and the IC pins
Logged
 

Offline tchiwamTopic starter

  • Regular Contributor
  • *
  • Posts: 134
  • Country: ca
Re: Agilen 8563EC
« Reply #2 on: June 13, 2023, 05:29:15 pm »
If I keep the span around 1MHz and add a signal I can see something ...

Well once I get the part... if it works or not... I'll let you know. And I hope this thread will be useful to someone someday.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee