Electronics > Repair
Agilent 34461A Error Codes
(1/1)
Metex:
Welcome!
First of all, I wish everyone a happy new year!
I want to ask for help.
I have an Agilent 34461A with the error codes shown in the picture.
I updated to version 3.03.
Sanos, that didn't fix the error.
If anyone could help me with this, I would greatly appreciate it.
Welcome! Csaba
coromonadalix:
retry the self test with shorted inputs ...     seem you have some offset,  but   did the meter received some voltages / over currents or else before trying any fw updates ?   

history ?
Metex:
I tried but same error.
As far as I know, he didn't get anything.
When the 1.09 update was on it, these errors were not present, only the AC offset error, which was corrected with the new update. Maybe I made the mistake of accidentally starting a calibration with open inputs? I read that maybe the zero points are gone?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod