Electronics > Repair
Agilent 6813B Power Source / Analyzer defective (CC)
(1/1)
Quester:
Hello,

short question, since I am at the very beginning of the process:
I got here an 6813B Power Source, that was from some
abandoned storage.

Many functions where out of Spec, an initializing and
re-adjustment solved most of the problems....

But CC-Mode is not working!

No matter what current I key in, the device will limit
the output-current to a much lower value than desired (1/3 or lower)
(but with higher current-limit keyed in, the current rises).

As said: it's calibrated/adjusted (by the way: the reading/measured value
on the Display is the actual floating current, so that is right).

Since I do not have the adapter service kit 5063-2330 and have much respect
regarding the high voltages inside I don't want to start
fault-search from the scratch (but will if to other way)
and I am hoping someone out there might know:
"Yesssss, I know - it's common, it's cable/part xyz..."

Error routines ending with "0".

Looking forward for some hints.
Thanks and best regards.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod