Electronics > Repair

Agilent DSO3202A

(1/1)

Select-test:
Hello Everyone,

I have an Agilent DSO3202A and 3 of the controls go wacky [attachimg=1](see Pic). In other words, are not linear. I dismantled the keyboard but couldn't find the part #. Would anyone know what part # these are ?

Thanks for any assistance.

Martin

kubark42:
I had a similar problem on an Agilent DSO1002A, only it was the time and voltage scale buttons. Spraying in contact cleaner cleared things up right away. I don't even need to take the scope apart, it was enough to full firmly on the knobs to remove them, and then guide the contact cleaner in around the exposed shaft. I gave each knob a few whirls, pushed the button a time or ten, and it cleared right up.

Did the same with the push buttons and they started behaving a lot better, too.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version