Agilent E3634A Repair and a question.

[Runco990]

Back again!  This time it's an Agilent E3634A power supply.  I traded my previously repaired E3631A to a friend in favor of this one, as I require the occasional 48V at a higher current, so this one is perfect for my needs.

I have actually repaired it already, BUT...  I am looking for replacement binding posts....  As usual, someone just HAD to hamfist this and gouge up the front of all the jacks.  It's usable, just UGLY.

I have been looking, but does anyone know where I could find a replacement set?  These are the type that solder direct to the circuit board by the looks of it.

Also looking for a rear bezel.  (missing, but not a deal breaker)
This supply is NOT like the E3431A which has individual jacks that has wires soldered to them, so the standard posts don't fit.  It's an integrated assembly.

Attached a pic... of course it's an obsolete part....