EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: Runco990 on August 07, 2021, 05:10:11 pm
-
Back again! This time it's an Agilent E3634A power supply. I traded my previously repaired E3631A to a friend in favor of this one, as I require the occasional 48V at a higher current, so this one is perfect for my needs.
I have actually repaired it already, BUT... I am looking for replacement binding posts.... As usual, someone just HAD to hamfist this and gouge up the front of all the jacks. It's usable, just UGLY.
I have been looking, but does anyone know where I could find a replacement set? These are the type that solder direct to the circuit board by the looks of it.
Also looking for a rear bezel. (missing, but not a deal breaker)
This supply is NOT like the E3431A which has individual jacks that has wires soldered to them, so the standard posts don't fit. It's an integrated assembly.
Attached a pic... of course it's an obsolete part.... :palm: