Electronics > Repair
Amazon Fire HD10 - Inductor?
(1/1)
andrew_c:
I have an Amazon Fire HD10 (2019) that won't charge. Outlet shows the tablet is pulling 2.5A, with or without the battery connected to the motherboard.

I have identified an inductor that is getting uncomfortably hot and has scorched the board. I feel like the inductor is just a symptom and not the cause. I've no FLIR camera, just alcohol. Tried to identify if a cap was shorted and getting hot - couldn't see anything outside of the shielding.

Great tablet, which I would hate to go to e-waste.

MathWizard:
So it's a tablet, with say a 12V or 5V wall-jack PSU ? What voltage is the battery ? IDK if anything on these would need a DC-DC step-up/boost converter, but there's probably a few DC-DC step-down/buck converters. Sometimes they have them in series on the input voltage too. They should be very low DC resistance, and not heat up much, even with a lot of current.

Do you know what circuit the inductor is part of ? Is it the black thing in the pic above the REV1 ? Or is that just another part with a bit of dirt of blackening around it ?

If it's part of a converter circuit, there should be a controller IC and diode or 2 and some mosfet, very very close to the inductor.

In general these PCB's, are a nightmare, because they have so many layers, traces disappear under all kinds of chips too, and then soldering on them and even just probing on them can be hard. And then a lot of the chips probably won't have public datasheets, and they might not have a label, or anything a search engine can find.

If you are a lucky, it is just a power type issue, and has nothing or little to do with any chips, or operating systems, besides some power controller IC, or MCU.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod