| Electronics > Repair |
| Another blown Agilent 4263B |
| << < (3/3) |
| TERRA Operative:
Sounds good. I have a few spare bare PCB's of my 4-wire standards linked above, so we could maybe do a trade, or something. (They are small and hence cheap to order anyway). |
| mawyatt:
Somehow missed this project, like the direct BNC connections with 3D printed levers, nice :-+ We have a Hioki IM3536 (8MHz) that was purchased new a couple years ago and been in our lab in the same spot since, also a Tonghui TH2830 (100KHz) purchased new just before the IM3536 and also in same spot since. The lab operates with 25C and 42~45% RH 24/7. Also 3 KS34465As, DMM6500, SDM3065X and a HP34401A and AG34401A. We can offer some measurements if you wish. An option might be to use some small value Caps like Polystyrene, Mica and NP0/C0G for measurement, then shipped. The latter types are available and not too expensive in 1% types up to 0.1uF. Anyway, nice project ;) Best |
| Navigation |
| Message Index |
| Previous page |