Electronics > Repair
Aoyou 701A++ solder/desolder station replacement parts
(1/2) > >>
Southerner:
A couple years ago I bought one of the Aoyou 701A++ solder/desolder stations but have not had very good luck with it.  The compressor/vacuum pump seems to lack the needed suction to clean holes.  Does anyone know of a replacement compressor/vacuum pump for these that will actually do the job?  When I searched I only saw one place that listed replacement parts and listed a Aoyou P001 compressor but it was not for the 701 and even if it was it needs a bit more power.  Has anyone replaced that pump in theirs?  What did you use and where did you find it?

I have also looked for a complete parts list and diagram for the 701 since the instruction manual PDF only lists soldering iron and desoldering gun parts and not the main unit parts.  I have also not had good luck finding anyone that stocks consumables for this.  I was looking for a replacement tip but SRA and the other place I saw
https://gsmserver.com/equipment/soldering-equipment/spare-parts-for-soldering-equipment/
also shows the parts but not available.

Thank you.
Southerner:
The Aoyou instruction manual for the 701A++ does not have a parts breakdown for the main unit, only the gun and soldering iron.  I did more looking and looked at the Hakko 701 manual on the Hakko site.  No parts breakdown showed up until the early manual for the 701 which was in 2009.  It listed the Hakko B2444 compressor but searches for that part on the Hakko site return "no find" which makes me think it is no longer available.  I do have to wonder though if I found one somewhere if it would fit in the Aoyou and work.  Anyone have any knowledge about that?

Thank you.
BravoV:
Older Hakko like 474 has manual with complete tear down view (just google), and the compressor it self is not for sale in stand alone unit, but in smaller parts.

Whats your suction pump look like ?
Southerner:

--- Quote from: BravoV on October 09, 2020, 07:31:14 am ---Older Hakko like 474 has manual with complete tear down view (just google), and the compressor it self is not for sale in stand alone unit, but in smaller parts.


--- End quote ---
$234 for the B2064 pump for the Hakko 474  is a bit much for a replacement pump/compressor for a $170 station.  I was hoping to find something cheaper than that.

Thank you.
aqibi2000:
Aoyue  2901/2900 70W
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod