Electronics > Repair
BM257 (Elma) in DC Voltage (Auto) - Just pulses the "bargraph" - Doesnt show 12v
(1/1)
bingo600:
My (out of support) Elma BM257 had developed a weird error, while stored.

When switching to DC Voltage , it just pulses the "Analog bargraph" , and just hangs there.



I tried to connect the probe pins to my PSU set to 12v , but it just kept on pulsing.
If i manually try to switch the ranges , then at one of them it shows 0.00v , the rest OL.
None of the ranges vill detect the 12v connected to the probes.

Other functions work fine - Ie. Ohm shows 0.001 when shorting the test leads.

I don't see any "Cal errors" when switching to DCv

Any hints ??

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod