Electronics > Repair

Bugs in KSGER C245 - how to solve?

(1/2) > >>

I got a new KSGER C245. Unfortunately the software menu fails and the display output is not fully to see on the right side. Is there an easy fix getting rid of those problems? Are there schematics available for this device?

the character output is distorted. The device has to be switched off.

the °C text output is located too much to the right. The display should be shifted to the left.   

Seems like a connection problem. Check the solder joints.

I agree with DavidAlfa that it's probably some connection problem. Maybe the flex to the display?

There are a lot of variations of very similar soldering stations, and both schematics, (KiCad projects) and firmware for variants can be found on github / gitlab and similar sites.


[0] Message Index

[#] Next page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod