Electronics > Repair

Can someone help identify these caps?

<< < (6/8) > >>

phlegeton:
Thanks for this. Maybe a stupid question, how can I measure the voltage. When the drive is in chassis, I can't reach it.

fzabkar:
Attach the PCB to the PSU in a desktop PC?

phlegeton:
I only have to power up the pcb, and the drive doesn't have to be attached? In that case, I could also use my lab power supply. I have a SATA power cable, I attach picture of it. If I can use that one, that would make things much easier.

fzabkar:
Yes, all we're doing is confirming whether the 5V supply is being cleaned up before it gets to the preamp. In fact, just do a continuity check. That should be enough. No need to power up the drive.

phlegeton:
I wasn;t sure if the drive needs to be connected for load. I checked, and yes, there is continuity between the +5V and the 5V e-fuse.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod