Electronics > Repair

Cleaning up solder from a stubborn thruhole

<< < (13/13)

kaindub:
I only saw one mention of this method.
I had similar problems of clearing holes until I tried this method.

I get a solder sucker, but you need the build type because you want to blow the solder clear through the hole.
Apply a little solder to the pad so the solder is slightly above the surface.
Then heat the solder and blow through the hole with the solder sucker.
Works most of the time. There may be a little tail left on the reverse side of the board

Robert

digital:
Use a pin vise and a twist drill the same diameter as the component lead and just be careful and it will work,be gentle.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version