| Electronics > Repair |
| CMU200 Rohde & Schwarz hangs during BaseDiscoverOptionsBegin |
| << < (3/9) > >> |
| Qw3rtzuiop:
Hello my cmu200 has now a similar problem. The error apears on every start up. I removed all unnecessary options and modules without any success. Has anyone a guess what part may be defective? |
| RF_fanatic:
It might seem strange but check the connector between the Frontend module and the mainboard (the grey multiwire cable) If I remember correctly I have also seen such message when that cable was not making proper contact, but I can be wrong.. |
| Qw3rtzuiop:
I checked the connectors but that didnt helped. But i updated all the software to the latest version. Now the cmu is bootin up. But the spectrum display is empty. There must be a fault in the DIG module. Either the adc or the DDC/DSP board. |
| tech255:
I have a machine that throws up errors like this when i try to install B17 and B21 modules im looking for an install version of "version manager" so i can wipe my drive and reinstall the version manager and then the software. I would also like to install an earlier software if anyone has copies of these i have all the latest 5.1 and 5.2 versions. I have no idea what versions were previous. |
| Bicurico:
Hi, I received two CMU200 with broken DSP board 1100.3220.02. Just a quick question (I am in the office and can't test it now): what happens if I remove this board? Will I just lose the WDCMA functionality or will the bas spectrum/generator functions stop working, too? Does the CRTU have this board, too? Are they exchangeable between CMU200 & CRTU? Regards, Vitor |
| Navigation |
| Message Index |
| Next page |
| Previous page |