Electronics > Repair
Console repair: Help identifying components
<< < (3/3)
newtekuser:

--- Quote from: wraper on July 13, 2024, 08:23:08 pm ---What actual resistance is that "shorted"? CPU/GPU and RAM may have very low resistances on their power rails. Also those converters can easily get shorted to the ground.

--- End quote ---

Ah, I forget that these have very low resistances  :palm: I measure 4 ohm on one side and 0.3 ohm on the other side of the resistors.
wraper:
Resistance may be fine depending on what power rails those are. I'd expect converter IC to be dead if a ferrite bead in its input failed open/burned. The issue is that if upper mosfet (between Vin and out) inside the IC fails short first, it may take out (overvolt) the load as well.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod