Electronics > Repair

Coupler on old Hameg scope

<< < (3/3)

p2potter:
Thanks everyone for the responses. I will contact various folks as the second picture in the last post is exactly what i need. The Amazon coupler i bought works, but it is big and looks really ugly (bright metallic blue!).

Thanks,

Phil

oz2cpu:
sorry to kick alive old thread,
but i just solved the same problem , same broken nylon part, same Hameg brand
I 3D designed and 3D printed the part, works perfectly fine,
I also shared the file for free on thingiverse
https://www.thingiverse.com/thing:6894218

cte:
Maybe I can add to this...

I needed replacement for the red plastic part used on the vertical amplifier board for the "5x magnification".

My solution has to be printed in two halfs (one has to be mirrored) and then glued together.

oz2cpu:
CTE thanks for sharing
did you also put the files free available on thingiverse or similar ?

cte:
No, not yet. Never made an account there. Maybe I should...  :clap:

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod