EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: marnav1 on December 17, 2024, 12:27:54 am

Title: Cover removal Tek T935 input board
Post by: marnav1 on December 17, 2024, 12:27:54 am

Any suggestions for disassembly? I'd like to clean the switches underneath. Very little room to remove those nuts, its smaller than it looks in the picture.

Title: Re: Cover removal Tek T935 input board
Post by: alan.bain on December 17, 2024, 10:58:21 am

I seem to remember having to resort to needle nosed pliers (horror) for the BNC back nut.  I would love to know what the correct tool is....  Don't forget to desolder the resistor first or it is easy to destroy.

Alan

Title: Re: Cover removal Tek T935 input board
Post by: ondraN on December 17, 2024, 11:32:28 am

For this type of work I use nose pliers and radius nose pliers. After loosening the nut I use tweezers to finish. Disassembly is easier than reassembly, so I wish you good luck.

Title: Re: Cover removal Tek T935 input board
Post by: marnav1 on December 17, 2024, 12:14:22 pm

Ok ty gentleman, this sounds like if you dont really need to mess with it dont lol.

Title: Re: Cover removal Tek T935 input board
Post by: ondraN on December 17, 2024, 12:38:16 pm

I'm currently working on repairing and renovating a Tek 453. It's really hard work and a real puzzle. The T935 is amazingly simple in comparison  :)