Electronics > Repair

Cover removal Tek T935 input board

(1/1)

marnav1:
Any suggestions for disassembly? I'd like to clean the switches underneath. Very little room to remove those nuts, its smaller than it looks in the picture.

alan.bain:
I seem to remember having to resort to needle nosed pliers (horror) for the BNC back nut.  I would love to know what the correct tool is....  Don't forget to desolder the resistor first or it is easy to destroy.

Alan

ondraN:
For this type of work I use nose pliers and radius nose pliers. After loosening the nut I use tweezers to finish. Disassembly is easier than reassembly, so I wish you good luck.

marnav1:
Ok ty gentleman, this sounds like if you dont really need to mess with it dont lol.

ondraN:
I'm currently working on repairing and renovating a Tek 453. It's really hard work and a real puzzle. The T935 is amazingly simple in comparison  :)

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod