I've been noticing that b/c my model is a D90 and the schematic is for a C90, some things are a little different, but most are in the right place. On the neck board the 2 capacitors are
C490 10uf 250V @208 VDC
C930 470uf 16V @ 13.5 VDC
Caps near the jungle chip
C201 220uf 16V @ 13.5 VDC
C403 470uf 16V @ 9.4 VDC
C265 220uf 16V @ 11.4 VDC
C510 2.2uf 50V @ 11.4 VDC
C268 on my board is ceramic and I just can't locate 267, at least there isn't an electrolytic cap with that position.
I did, though, to my chagrin, notice this.
That's the neck board service switch. On the left is before I did any work on it, the right is as of today. It got knocked off during the recap somewhere.
I don't know what exactly it would cause, but I'd guess either it doesn't matter too much or that it's bad.
Also, if viewing the mainboard and deflection boards post recap from the underside would help, I can post some detailed photos. I'll have time tomorrow to do so.
*Edit* My solder does have a flux core, I believe, but I also use a no-clean tack flux syringe when soldering.