« previous next »
Pages: [1]   Go Down

Author Topic: D-shapped connector identification  (Read 1291 times)

0 Members and 1 Guest are viewing this topic.

Offline hcbjuniorTopic starter

  • Newbie
  • Posts: 1
  • Country: br
D-shapped connector identification
« on: April 06, 2016, 06:53:23 pm »
Hi All,

I need to repair a Toshiba Nemio XG keyboard's cable, but i could not find whitch connector it uses.

There is an image attached. There are 26 pins on it.

Thanks.

Logged
 

Offline Gyro

  • Super Contributor
  • ***
  • Posts: 10083
  • Country: gb
Re: D-shapped connector identification
« Reply #1 on: April 06, 2016, 07:29:50 pm »
That looks rather like the small (miniature) Amphenol parallel port connector that HP used to use on some of their laser printers, not sure about the pin count though.
« Last Edit: April 06, 2016, 07:32:57 pm by Gyro »
Logged
Best Regards, Chris
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee