Electronics > Repair
Datron 1271 repair
<< < (6/7) > >>
picburner:
I also noticed a discrepancy between the dump generated by the pelule and rigrunner scripts: in practice from the address 0x0000 to 0x07ff they are identical instead from 0x0800 to 0x1fff they differ completely.
I have a 1271 with firmware v2.10 and the last digital pcb.
As soon as I can I try to do another check with TheSteve script's.
Mickle T.:
Does anyone have an idea how to enable an option 40 "Comprehensive Ratio" in Datron 1271?
picburner:
I can tell you how to enable option 70: with the jumper highlighted in the picture (adding the missing components of course in my case only the AD7545).
Only one jumper on the side remains, which perhaps could activate option 40? (I am missing 2 relays and 1 coil and I can't try it).
picburner:
I just did a test between the three different scripts of the three authors.
Pelule and TheSteve's scripts give identical results, rigrunner script's has the difference mentioned above.
Attached are the dumps obtained and the comparison.
rigrunner:
Looks like my original order is the culprit.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod