So, recently the server refuse to start and reported this error code: "E1215 1.8V PwrGd", which basically means that there is a problem with the voltage regulator for 1.8V. On that server, this voltage is created (controlled) by the motherboard (since the PSU only delivers +12V and +3.3V).
Till now I have tried to start it with the bare minimum number of components and the result was the same.. even I tried without RAM - no change, same error.
The question is - does anyone know where and what to check on the motherboard?
Also, I'm thinking for the worst scenario (fried chipset or something similar) - what are the chances of that?