Electronics > Repair
Denon SC6000 RJ45 Link socket
(1/1)
Audiorepair:
OK, so I need to replace the RJ45 link socket on a Denon SC6000.

After searching Mouser, I came up with this which is an identical size and footprint.
https://www.mouser.co.uk/ProductDetail/960-TMJ0162GDNL

Only it doesn't work (and the right yellow LED is the opposite polarity of the original)

A bit of Googling the data sheet shows the pinouts are clearly not compatible with the Denon configuration you can see in the photo of the PCB.
https://www.taoglas.com/datasheets/TMJ0162GDNL.pdf.  Section 4.1 shows the pinout.

The Denon has I presume 4 pairs of data lines.

Now this is when I realise that I don't have a clue about any of this, the RJ45 is not the Universal connector I presumed it was, and I'm not even that sure what T10/100 base blah blah is either.


So the question is, what should I actually be looking for in my Mouser (etc) search parameters?
What are Denon doing  here?
Audiorepair:
So I've managed to find almost what I'm looking for now.

This datasheet has circuits C & D which appear to be very similar with what I pulled from the Denon.
https://www.mouser.co.uk/datasheet/2/706/fastjack_gigabit-520265.pdf

They show Pin one as VCC, though in the Denon it is connected to ground along with pin 10.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod