Electronics > Repair

DS Lite.

(1/2) > >>

zerorisers:
Hello everybody, zerorisers here.
I have an old nintendo DS Lite. problems that I have are that the pads for the power switch are lifted and the ribbon cable for the top lcd keeps shorting. Anything that I can do about either of these problems? (ribbon cables short because of wear and tear on the plastic coating I believe, so if I have it layed out in a particular way I can get a picture.)

tautech:
Power switch could maybe bodged, is it momentary or off/on 2 position?
For the ribbon, chop up an old PC IDE HD cable for a replacement. Assuming it is for LV?

wagon:
You can buy pretty much every part for the DS off Ebay.

zerorisers:
Thank you both for the reply's, I don't have much money so I am attempting a cheaper alternative. This will be for personal use. The power switch in completely gone off the board.

wraper:

--- Quote from: zerorisers on August 09, 2014, 10:41:07 pm ---I have an old nintendo DS Lite. problems that I have are that the pads for the power switch are lifted and the ribbon cable for the top lcd keeps shorting.

--- End quote ---
If it has damaged insulation, then you can just put a piece of insulating tape on it. If it does not help, some conductor is broken.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks WYSIWYG Editor
Powered by SMFPacks Advanced Attachments Uploader Mod