Few months ago I bought this guy as broken and finally I got service manual, now is time to repair.
First of all I found that +- 15V rails are not so good.
Two 15ohm resistors are broken but why? After replace magic smoke escaped
Aha tantalum caps
both at output had resistance around 50ohm (not so common that they are not fully shorted).
Now is time to order some spare parts.
Question is what to use as replacement for those tantalum bastards. What is your suggestions guys?
Again tantalum or electrolytic or ceramics? Because most of them are 4.7uF/20-40V.