I measured an internal test point according to the document I found here (on page 3), and it measured 8.39109MHz without locking. While being out of tolerance, the sine wave appears to be very clean and noise free from just looking at it on my scope (will hook it up to the spectrum analyzer later when my coworker is done using it). That is extremely out of tolerance, but I have no clue as to what that could be from. Another thing I noticed is that even though it has all the parts that would take 5V, the pin on the DE-9connector which is supposed to take 5V does not actually draw any current at 5V. This could explain why I am not getting an output on the DE-9, but not why the frequency way out of tolerance.