Electronics > Repair
Fixing Rohde & Schwarz FSIG (FSEA, FSIQ...) Ascom power supply
<< < (4/9) > >>
av500:
And now for the conclusion:

- repaired the PCB with UV cure solder mask, the UV lamp did not arrive but the sun was shinning  8)
- soldered the replacement caps
- put it all together for a dry run, 5.499V analog on the meter  :-+
- reassembled the PSU and back in the case, the FSEB is one happy camper again
mpcengineer:
Hi. Does anyone have the part numbers for the 9 way mating connector? Please.

I need to test my PSU.

Thanks

MPC
av500:
I bought this one: https://www.mouser.de/ProductDetail/TE-Connectivity/350712-1?qs=OHKvVYVKKrfVmRRZ4oQI7w%3D%3D
paul@yahrprobert.com:
For R&S boat anchors that don't boot up see this thread:
https://www.eevblog.com/forum/testgear/rohde-schwarz-fsae-30/msg3238578/#msg3238578

The problem was a dead resonator on a PIC chip on the CPU board.  Symptoms are a black screen, no boot, no sound, almost seems like a dead power supply
mpcengineer:
Hi. Do not use the Molex version of this connector the crimp pins are too large. The TE Mate-N-Lok works okay.

https://uk.rs-online.com/web/p/pcb-headers/0849041

I am having a problem with the PSU shutting down when switching from standby to ON. The fans give a short rotation, then shutdown. I have noticed if I leave the analyser on for several minutes in standby then the unit will power up.

I have setup a test jig for the PSU and found the 15V is going over voltage. Please see oscillogram.

I noticed in this thread there is mention of the UC3845 reference going faulty. Any idea which is the UC3845 controlling the 15V.

Thanks. MPC
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod