Electronics > Repair
Fixing Rohde & Schwarz FSIG (FSEA, FSIQ...) Ascom power supply
(1/9) > >>
OH2LIY:
Hello, once again my R&S FSIG SA refused to work. This time symptons was just blinking stby led. This was 3. or 4. time when this SA was broken. Every time I have managed to find and fix broken components.
Once again I grabbed manuals and find that there is only very short description of power supply functions, not even block diagram, only voltages&pins was described. Just to remove PS from SA takes closer to one hour. After that, fun begins. Opening power takes other hour... After long and hard thinking and testing, I did managed to find short circuited ceramic cap. Capasitor was between 4/8 pin on CA258 (LM358) and it short circuited +12V and -12V lines. 
After replacing cap, stby power started nicely and also main power started after pressing front panel main switch!

pinyoro:
Well done!

Sent from my WAS-LX1A using Tapatalk

Huluvu:
Long time not seen our PSU for R&S  8)
Must be almost 15 years old  :-+
Can you please take a picture of the label at the side of the PSU
OH2LIY:
My mistake, I didn't take photo from label (actually, I did this repair over month ago and last weekend was time to fix HDD, and again I did have to remove power and so on). I'll take photo next time (hopefully not too soon)...


Ramppa
OH2LIY:
Huluvu, forget to ask, but do you have schematics for PS?


Ramppa
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod