Electronics > Repair

Fixing Rohde & Schwarz FSIG (FSEA, FSIQ...) Ascom power supply

(1/9) > >>

OH2LIY:
Hello, once again my R&S FSIG SA refused to work. This time symptons was just blinking stby led. This was 3. or 4. time when this SA was broken. Every time I have managed to find and fix broken components.
Once again I grabbed manuals and find that there is only very short description of power supply functions, not even block diagram, only voltages&pins was described. Just to remove PS from SA takes closer to one hour. After that, fun begins. Opening power takes other hour... After long and hard thinking and testing, I did managed to find short circuited ceramic cap. Capasitor was between 4/8 pin on CA258 (LM358) and it short circuited +12V and -12V lines. 
After replacing cap, stby power started nicely and also main power started after pressing front panel main switch!

pinyoro:
Well done!

Sent from my WAS-LX1A using Tapatalk

Huluvu:
Long time not seen our PSU for R&S  8)
Must be almost 15 years old  :-+
Can you please take a picture of the label at the side of the PSU

OH2LIY:
My mistake, I didn't take photo from label (actually, I did this repair over month ago and last weekend was time to fix HDD, and again I did have to remove power and so on). I'll take photo next time (hopefully not too soon)...


Ramppa

OH2LIY:
Huluvu, forget to ask, but do you have schematics for PS?


Ramppa

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod