Electronics > Repair
Flamezum 2000/4000 watt PSW inverter question
(1/1)
Dubyagee:
Hello

I have one of these inverters and the output is wonky. The display on the unit shows a higher wattage being consumed than the killawatt does. It acts like a 750 watt inverter. The sine wave shows a solid wave on an oscilloscope and the voltage stays at 120 volts under a 500 watt load. Is there an adjustment for the display to show true output and have the safeties respond to the correct load?

Thanks in advance.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod