HolĂ . Ingles aqui por favor...
Soft Reset
A Soft-Reset will not reset the master installer code or user code. A soft-reset will reset the zone programming etc. All devices will be deleted.
To perform the Reset:
Enter Installer Mode.
Scroll through the menus until you see FACTORY DEFLT, Press <OK>.
Display will show <OK> to restore, Press <OK>.
Display will show ENTER CODE, enter the master installer code.
Display will show PLEASE WAIT... for a short time, after which the factory defaults will have loaded.
The display will revert to FACTORY DEFLT.
Hard-Reset
A Hard-Reset will reset the Master installer code to 9999 and the user code to 1111.
To perform a hard-reset on the Powermax Pro control panel;
Remove the mains power to the control panel.
Open the control panel and disconnect the battery.
Identify the 3 pins marked DEF
Fit a jumper across the D and E pins
Apply battery power to the panel for approximately 10 seconds.
Remove battery power from the panel.
Remove the jumper from the D and E pins.
Re-connect the battery.
Close the panel and apply mains power.