Electronics > Repair
Fluke 199C Scopemeter a non starter
(1/1)
paf123:
"Hugoneus" thanks for the heads up. I have a 199c with no boot issue. I ran the D-Asic mask memory test and all was ok. I then removed the memory module ran the tests again and it still passed go figure ?? I probed all the obvious critical stuff and all seemed ok but not knowing anything definitive about the D-asic mask software it was looking like the runtime software was failing i.e. not loading or corrupt. What to do I was about to embark on "feedback.loops" memory card development, programming  path and then stumbled across your post re the D-ASIC balling often failing so I put a bit of pressure with my finger on it hit the on button and bingo everything works. Now how to permanently  fix it is the next problem.

cheers
xiaotaozi:
I made a dual flash module to see if there are any needed
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod