Electronics > Repair
Fluke 199C scopemeter repair
<< < (21/27) > >>
feedback.loop:

--- Quote from: calin on June 01, 2022, 01:13:02 am ---Yes, I will make a good photo once I get it. I dropped them a message and they did confirm that it comes with connector and flat flex cable. Looks like is the same guy that is behind http://scopemeterrepair.com/

--- End quote ---

Have you received this replacement part? I would love to see what it actually looks like. Thanks.
Ferrum:
feedback.loop thanks for your work!
Your work helped me a lot and greatly simplified the installation of new batteries.
EHT:
I'm still wondering if anyone has had to attempt replacement of the backlight or entire LCD. I see that the repair site listed above want $400 for a USED one, obviously not economically viable and may not last long anyway.
Ferrum:
Collected manuals and diagrams for you

https://mega.nz/folder/tJBRABrS#F_W2j4ED2dR7qS0YI_zkxw


https://www.manualslib.com/products/Fluke-Scopemeter-199c-2783159.html
timeandfrequency:
Many thanks feedback.loop for your comprehensive work on repairing Scopemeters.


***** How to retrieve the actual serial number of your Scopemeter *****

Context
I could not upgrade the firmware of my Fluke Scopemeter 199C because it once went to Fluke for repair/upgrade. They must have changed the motherboard. The number on the sticker (located at the rear of the device) did no longer match with the actual serial number of the motherboard. On the latter, I could not locate any sticker with a valid serial number.


How to?
So I wiretapped the serial connection to get the actual serial number of the motherboard.
Details on how to proceed are provided in the attached 7z file.



Enjoy
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod