Electronics > Repair
Fluke 199C scopemeter repair
<< < (27/27)
softy2k:
If I have software version 8.04 is possible to install 8.04 whit Bus Healt ?
I want to 'upgrade' from 199C to 225C
feedback.loop:

--- Quote from: softy2k on June 10, 2024, 06:38:19 am ---If I have software version 8.04 is possible to install 8.04 whit Bus Healt ?
I want to 'upgrade' from 199C to 225C

--- End quote ---

Yes.
https://www.eevblog.com/forum/repair/fluke-199c-scopemeter-repair/msg5022781/#msg5022781
softy2k:
Thanks for feedback.

But, in your message you said :
--- Quote ---I believe I used this flash tool before to upgrade version 7+
--- End quote ---
.

My Fluke 199C is not at home right now and already have 8.04 installed.
I hope will work 8.04 over 8.04
feedback.loop:

--- Quote from: softy2k on June 10, 2024, 05:56:57 pm ---Thanks for feedback.

But, in your message you said :
--- Quote ---I believe I used this flash tool before to upgrade version 7+
--- End quote ---
.

My Fluke 199C is not at home right now and already have 8.04 installed.
I hope will work 8.04 over 8.04

--- End quote ---

I did that. it works.
xiaotaozi:
I made a dual flash module to see if there are any needed
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod