Electronics > Repair
Fluke 199C scopemeter repair
<< < (11/27) > >>
feedback.loop:

--- Quote from: asis on June 17, 2021, 10:17:22 am ---
I copied working dumps v702, v804 from them and made an UPDATE to Fluke 225C with busheat and language support.


--- End quote ---

Could you share the dumps please?
Thank you.
Assafl:
Thanks for your videos. I put together a LiIon battery from a discarded bike battery and it works great (they are old 2200mAh cells - so they last "only" 7 hours! - and you don't have to fret the battery going dead for months).

Were you able to update to 225c?
AFAIK Bushealth option is a 10 character code away: Under USER -> VERSION & CAL menu click F1. 
feedback.loop:

--- Quote from: Assafl on September 30, 2021, 11:42:13 am ---Thanks for your videos. I put together a LiIon battery from a discarded bike battery and it works great (they are old 2200mAh cells - so they last "only" 7 hours! - and you don't have to fret the battery going dead for months).

Were you able to update to 225c?
AFAIK Bushealth option is a 10 character code away: Under USER -> VERSION & CAL menu click F1.

--- End quote ---

Do you know how to update to 225C?
Assafl:

--- Quote from: feedback.loop on October 01, 2021, 03:12:24 am ---Do you know how to update to 225C?

--- End quote ---

Click on F1 in the VERSION & CAL menu.


Click on F1


I don't know what the code is though. An online search came up empty. I didn't even come across an option to update from Fluke. Maybe it was a shelved upgrade path?
asis:
Hi,
Static SRAM (CY62147CV33) located on the module A201 together with FlashRAM (ST39VF800A) is used to save TrendPlot Waveform and Setup data in Recorder mode.
Therefore, even if the scope is turned off, the module is still powered and consumes current until the battery is completely discharged.
In addition, the RTC is also powered by a battery.
Ultimately, the battery is completely discharged, which can lead to its complete degradation.
Therefore, after you have measured and saved the results, try to upload the data to the FlukeView SW as quickly as possible.
I suggest installing some kind of switch in the device that physically disconnects the battery and thereby extends its service life.
(Which, in fact, did).
The disadvantage is that the next time you turn on the device, you need to set the Date / Time, if this is important when creating reports.
Remember to turn on the switch to charge the battery.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod