Electronics > Repair
Fluke 199C scopemeter repair
<< < (13/27) > >>
Assafl:

--- Quote from: feedback.loop on October 01, 2021, 03:12:24 am ---
--- Quote from: Assafl on September 30, 2021, 11:42:13 am ---Thanks for your videos. I put together a LiIon battery from a discarded bike battery and it works great (they are old 2200mAh cells - so they last "only" 7 hours! - and you don't have to fret the battery going dead for months).

Were you able to update to 225c?
AFAIK Bushealth option is a 10 character code away: Under USER -> VERSION & CAL menu click F1.

--- End quote ---

Do you know how to update to 225C?

--- End quote ---

This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/
feedback.loop:

--- Quote from: Assafl on October 07, 2021, 06:53:07 pm ---
--- Quote from: feedback.loop on October 01, 2021, 03:12:24 am ---
--- Quote from: Assafl on September 30, 2021, 11:42:13 am ---Thanks for your videos. I put together a LiIon battery from a discarded bike battery and it works great (they are old 2200mAh cells - so they last "only" 7 hours! - and you don't have to fret the battery going dead for months).

Were you able to update to 225c?
AFAIK Bushealth option is a 10 character code away: Under USER -> VERSION & CAL menu click F1.

--- End quote ---

Do you know how to update to 225C?

--- End quote ---

This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

--- End quote ---

Yes, that worked! Thank you very much!
mr.fabe:

--- Quote from: Assafl on October 07, 2021, 06:53:07 pm ---This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

--- End quote ---
Do you know if recalibration is necessary after using this flash tool?

Thanks!
Enginerding:
@feedback

Great attention to fine details in your vids.

Any chance you have one of those PCB's left, or can share the gerbers you made?
Assafl:

--- Quote from: mr.fabe on October 08, 2021, 11:32:27 am ---
--- Quote from: Assafl on October 07, 2021, 06:53:07 pm ---This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

--- End quote ---
Do you know if recalibration is necessary after using this flash tool?

Thanks!

--- End quote ---

According to https://www.fluke.com/en-us/support/software-downloads/fluke-190c-series-or-2x5c-series updating to 8.x needs recalibration if updating from 6.xx versions. For 7 & up recalibration isn't necessary (at least according to the Fluke site).
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod