Electronics > Repair

Fluke 199C scopemeter repair

<< < (13/20) > >>

Assafl:

--- Quote from: feedback.loop on October 01, 2021, 03:12:24 am ---
--- Quote from: Assafl on September 30, 2021, 11:42:13 am ---Thanks for your videos. I put together a LiIon battery from a discarded bike battery and it works great (they are old 2200mAh cells - so they last "only" 7 hours! - and you don't have to fret the battery going dead for months).

Were you able to update to 225c?
AFAIK Bushealth option is a 10 character code away: Under USER -> VERSION & CAL menu click F1.

--- End quote ---

Do you know how to update to 225C?

--- End quote ---

This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

feedback.loop:

--- Quote from: Assafl on October 07, 2021, 06:53:07 pm ---
--- Quote from: feedback.loop on October 01, 2021, 03:12:24 am ---
--- Quote from: Assafl on September 30, 2021, 11:42:13 am ---Thanks for your videos. I put together a LiIon battery from a discarded bike battery and it works great (they are old 2200mAh cells - so they last "only" 7 hours! - and you don't have to fret the battery going dead for months).

Were you able to update to 225c?
AFAIK Bushealth option is a 10 character code away: Under USER -> VERSION & CAL menu click F1.

--- End quote ---

Do you know how to update to 225C?

--- End quote ---

This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

--- End quote ---

Yes, that worked! Thank you very much!

mr.fabe:

--- Quote from: Assafl on October 07, 2021, 06:53:07 pm ---This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

--- End quote ---
Do you know if recalibration is necessary after using this flash tool?

Thanks!

Enginerding:
@feedback

Great attention to fine details in your vids.

Any chance you have one of those PCB's left, or can share the gerbers you made?

Assafl:

--- Quote from: mr.fabe on October 08, 2021, 11:32:27 am ---
--- Quote from: Assafl on October 07, 2021, 06:53:07 pm ---This works: https://xdevs.com/doc/Fluke/19x_2xxC_Scopemeter/fw_V804_225C_for_199C/

--- End quote ---
Do you know if recalibration is necessary after using this flash tool?

Thanks!

--- End quote ---

According to https://www.fluke.com/en-us/support/software-downloads/fluke-190c-series-or-2x5c-series updating to 8.x needs recalibration if updating from 6.xx versions. For 7 & up recalibration isn't necessary (at least according to the Fluke site).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version