Electronics > Repair
Fluke 199C scopemeter repair
<< < (17/27) > >>
alpher:
Hi, anyone care to share the latest firmware for 199c ?
Looks like Fluke pulled it from their website, I have one with firmware 7.02 and like to uppgrade to the latest.
Much appreciated.
feedback.loop:

--- Quote from: alpher on March 11, 2022, 10:07:31 pm ---Hi, anyone care to share the latest firmware for 199c ?
Looks like Fluke pulled it from their website, I have one with firmware 7.02 and like to uppgrade to the latest.
Much appreciated.

--- End quote ---

attached
feedback.loop:
This is a new version of the Li-ion battery pack for Fluke 19x scopemeters.



CORRECTION: the label on the battery pack should have said 6300 mAh. The donor pack was 3s2p, and I tested each PAIR before building the pack, and measured about 4200 each. But then the pack was reconfigured as 2s3p. Sorry about this confusion.
alpher:

--- Quote from: feedback.loop on March 13, 2022, 08:51:09 pm ---
--- Quote from: alpher on March 11, 2022, 10:07:31 pm ---Hi, anyone care to share the latest firmware for 199c ?
Looks like Fluke pulled it from their website, I have one with firmware 7.02 and like to uppgrade to the latest.
Much appreciated.

--- End quote ---

attached

--- End quote ---
Thx.
calin:
I just got a 199C ... with a bad keypad (this one seems usual); no battery and no fan.

Battery I got a new one of Amazon, just because I am lazy to make the amazing LiPo one that Feedbackloop has built.

I solved the fan issue with a Noctua NF-A4-X10 40x40mm I had lying around plus a bit of cable cutting. Yeah way too fancy and expensive but it was just sitting thrown in a box. It takes a tad more power than the standard one but I think is OK.

Now the keypad. I confirmed that the scopemeter works on all (most) functions emulating the keypad with a jumper wire .. CAREFULLY !!! and with a steady hand short correct row and column and Bob's your uncle. I found one for about 75$ on the fleabay but sincerely I would rather do the board mod rather than spending 75$ on a piece of paper waiting to go bad again soon. Does anyone has one to sell ? Maybe Feedbackloop  :)

Oh yeah the charger ... By miracle I had a laptop charger with the good voltage in the junk bin; a bit of cable surgery to flip polarity to negative center and put a normal barrel connector on its end and happy camper.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod