Electronics > Repair
Fluke 199C scopemeter repair
<< < (19/27) > >>
dirtcooker:

--- Quote from: calin on June 01, 2022, 01:13:02 am ---Yes, I will make a good photo once I get it. I dropped them a message and they did confirm that it comes with connector and flat flex cable. Looks like is the same guy that is behind http://scopemeterrepair.com/

--- End quote ---

I just bought one of these https://www.ebay.com/itm/231220191481
It took 10 minutes to install and my Fluke 199C is back up and running. The quality of the key contact board is excellent. Prior to the repair, my 199c powered up, responded to signals on the probes, but did not respond to any other keys except, holding down power and user reset to factory as intended.
minhhvktqs:
Hello
I have a Fluke 196C. But it is not working:((
This ram is bad.
Can you help me?
can you send me a file ( gerber....) for Module Ram.
Thanks u so much
dirtcooker:

--- Quote from: feedback.loop on October 03, 2021, 10:41:05 pm ---A dedicated programmer for Fluke 19x memory modules was developed including software in C for an Atmel microcontroller and a piece of software in Python to control the programmer from a PC.

--- End quote ---

fantastic work! I would be grateful if you could post gerbers for the memory modules. Even better if you could make the modules available for sale, perhaps on a kickstarter, and maybe a preprogrammed option too. I would certainly buy one for $100. I just replaced the keypad contacts in my 199c, and now it seems that the memory modules go bad as well. I was under the false assumption that Fluke stuff was indestructible. Given that a comparable fluke 190-202 costs US $5k, it is well worth having a spare module.

Note: to clarify, my 199c is working well now, but it would be nice to have some spare parts for it.
feedback.loop:

--- Quote from: dirtcooker on June 07, 2022, 07:35:26 pm ---fantastic work! I would be grateful if you could post gerbers for the memory modules. Even better if you could make the modules available for sale, perhaps on a kickstarter, and maybe a preprogrammed option too. I would certainly buy one for $100. I just replaced the keypad contacts in my 199c, and now it seems that the memory modules go bad as well. I was under the false assumption that Fluke stuff was indestructible. Given that a comparable fluke 190-202 costs US $5k, it is well worth having a spare module.

--- End quote ---

Do you mean that your module is fine, but you want to have a spare just in case? I doubt this is really necessary. Anything can fail, of course, but I don't think these modules fail often. And if you don't copy your module, but just buy some other random module, it will have different calibration and different serial number.

It would be cool to know how to change serial numbers, and even better to know how to read and write modules right in the scope. Fluke must have some utility for that I am almost sure.
smaultre:
Can anybody add the double flash dump   "low.bin and high.bin" as  pictired

For 199C  7.xx or any upgradeble to 8.xx flash?
And i need the same for 199B (Black/White LCD).
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod