Electronics > Repair
fluke 287 green led flashing
(1/1)
Gil31:
Hi everyone,
Here is my problem, I had the bad idea of ​​wanting to power my fluke with a 9v transformer, but there was 12v at the output!
The fluke turned on and off.
I put the battery back in to check if it turned on, but the green LED on the switch flashes and the fluke does not turn on anymore!
I started investigating, and I found a short circuit on the diode CR9, and the capacitors C79 and C67.
The 9v voltage arrives on Q20/Q21 but not further, maybe a problem with U20?
Thanks for your help.
Regards
Gil
coromonadalix:
refer to this thread    you may get some help

https://www.eevblog.com/forum/testgear/fluke-189iian-(289)-service-manual/msg4745819/#msg4745819
Gil31:
Thanks a lot !!
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod