Electronics > Repair
Fluke 289 not quite sorted.
<< < (48/49) > >>
MihaiV:
And the following photos...
MihaiV:
Here is the one on VAC...
MihaiV:
And mVAC.
maximalcho:
I forgot about the damn jumper. Good thing at least Kaiser remembered.I'm glad you made the multimeter too.
kaiser:

--- Quote from: MihaiV on March 22, 2022, 07:13:37 pm ---And mVAC.

--- End quote ---

Is it possible that the aligning holes on the rotary switch which mates to the rotary housing is out by 180° ?  I realise that one of the locating holes is larger than the other but possibly with enough force it will mate incorrectly..

P.S  Well done on your progress thus far..

K..
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod